Causes of Formation and Ways of Elimination of Defects on the Internal Surface of Upset Tube Ends
- Autores: Bogatov A.A.1, Erpalov M.V.1
-
Afiliações:
- Ural Federal University after the First President of Russia B. N. Eltsyn
- Edição: Volume 58, Nº 1-2 (2016)
- Páginas: 33-36
- Seção: Article
- URL: https://journal-vniispk.ru/0026-0673/article/view/235332
- DOI: https://doi.org/10.1007/s11041-016-9960-4
- ID: 235332
Citar
Resumo
Causes of formation of defects on the internal surface of oil tubes with ends formed by upsetting in SMS Meer hydraulic presses are considered. Interrelated requirements on billets and calibration of the equipment aimed at intensifying the upsetting process in one pass with growth of the wall thickening factor to about 1.85 are formulated.
Sobre autores
A. Bogatov
Ural Federal University after the First President of Russia B. N. Eltsyn
Email: m.v.erpalov@urfu.ru
Rússia, Ekaterinburg
M. Erpalov
Ural Federal University after the First President of Russia B. N. Eltsyn
Autor responsável pela correspondência
Email: m.v.erpalov@urfu.ru
Rússia, Ekaterinburg
Arquivos suplementares
