Email this article Cutting Methods for Thick Titanium-Alloy Slabs
- Authors: Polyanskii S.N.1, Butakov S.V.2, Mal’tsev L.V.2, Ol’kov I.S.2, Popov M.A.3, Aleksandrov V.A.4
-
Affiliations:
- Innovatsionnye Tekhnologii
- Yeltsin Ural Federal University
- VSMPO-AVISMA
- Ural State Agrarian University
- Issue: Vol 38, No 9 (2018)
- Pages: 694-698
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227518
- DOI: https://doi.org/10.3103/S1068798X18090241
- ID: 227518
Cite item
Open Access
Access granted
Subscription Access
Abstract
Methods of cutting thick titanium-alloy plates and slabs are considered. The surface quality of the cut and the productivity are estimated. Abrasive cutting by means of water jets is the most universal method and yields satisfactory surface quality at moderate cost.
Keywords
About the authors
S. N. Polyanskii
Innovatsionnye Tekhnologii
Author for correspondence.
Email: psn50@mail.ru
Russian Federation, Yekaterinburg
S. V. Butakov
Yeltsin Ural Federal University
Email: psn50@mail.ru
Russian Federation, Yekaterinburg
L. V. Mal’tsev
Yeltsin Ural Federal University
Email: psn50@mail.ru
Russian Federation, Yekaterinburg
I. S. Ol’kov
Yeltsin Ural Federal University
Email: psn50@mail.ru
Russian Federation, Yekaterinburg
M. A. Popov
VSMPO-AVISMA
Email: psn50@mail.ru
Russian Federation, Verkhnyaya Salda
V. A. Aleksandrov
Ural State Agrarian University
Email: psn50@mail.ru
Russian Federation, Yekaterinburg
Supplementary files
