Methods for Three-dimensional Prototyping and Printing in Reconstructive Neurosurgery

S. V. Mishinov; V. V. Stupak; N. V. Mamonova; A. A. Panchenko; I. B. Krasovsky; D. V. Lazurenko

doi:10.1007/s10527-017-9694-7

Methods for Three-dimensional Prototyping and Printing in Reconstructive Neurosurgery

Authors: Mishinov S.V.¹, Stupak V.V.¹, Mamonova N.V.², Panchenko A.A.³, Krasovsky I.B.³, Lazurenko D.V.⁴
Affiliations:
1. Ya. L. Tsiv’yan Science Research Institute of Traumatology and Orthopedics
2. OOO Engineering Medical-Technology Center
3. OOO Logeeks
4. Novosibirsk State Technical University
Issue: Vol 51, No 2 (2017)
Pages: 106-110
Section: Article
URL: https://journal-vniispk.ru/0006-3398/article/view/234947
DOI: https://doi.org/10.1007/s10527-017-9694-7
ID: 234947

Cite item

Full Text

Open Access
Restricted Access

Access granted
Restricted Access

Subscription Access

Abstract
About the authors
References
Supplementary files
Statistics

Abstract

The methods of three-dimensional printing widely used in the Russian Federation are discussed: FDM, SLA, SLS, and DMLS. Our own experience with three-dimensional modeling and prototyping of implants for reconstructive neurosurgical procedures is analyzed. An optimal method for three-dimensional printing of implants by direct laser metal sintering is developed and supported by evidence.