Email this article Effect of Caprolon Heat Treatment on Workpiece Turning Quality
- Authors: Erenkov O.Y.1, Otryaskina T.A.2
-
Affiliations:
- Pacific Ocean State University
- Komsomol’sk-na-Amur State University
- Issue: Vol 54, No 5-6 (2018)
- Pages: 444-447
- Section: Materials Science and Corrosion Protection
- URL: https://journal-vniispk.ru/0009-2355/article/view/236319
- DOI: https://doi.org/10.1007/s10556-018-0500-5
- ID: 236319
Cite item
Open Access
Access granted
Subscription Access
Abstract
Results are presented for an experimental study of surface layer quality for caprolon workpieces after turning. It is established that turning caprolon after preliminary heat treatment by the technology proposed leads to a reduction in machined surface roughness as indicated by values of roughness parameters and the type of chips obtained.
About the authors
O. Yu. Erenkov
Pacific Ocean State University
Author for correspondence.
Email: erenkov@list.ru
Russian Federation, Khabarovsk
T. A. Otryaskina
Komsomol’sk-na-Amur State University
Email: erenkov@list.ru
Russian Federation, Komsomol’sk-na-Amur
Supplementary files
