Email this article Investigation of the Structure and Hardness of Quenched Sintered Materials Produced from Iron-Base Alloyed Powders (Astaloy E)
- Authors: Ostovan F.1, Matori K.A.1,2, Yusoff H.M.3, Yunus R.3, Ariff A.H.4, Toozandehjani M.4, Meschian M.R.5
-
Affiliations:
- Materials Synthesis and Characterization Laboratory, Institute of Advanced Technology, University Putra Malaysia, UPM Serdang
- Department of Physics, Faculty of Science, University Putra Malaysia
- Department of Chemical and Environmental Engineering, Faculty of Engineering, University Putra Malaysia
- Department of Mechanical and Manufacturing Engineering, Faculty of Engineering, University Putra Malaysia
- Department of Material Engineering, Faculty of Engineering, Islamic Azad University of Majlesi
- Issue: Vol 58, No 7-8 (2016)
- Pages: 431-434
- Section: Article
- URL: https://journal-vniispk.ru/0026-0673/article/view/235009
- DOI: https://doi.org/10.1007/s11041-016-0030-8
- ID: 235009
Cite item
Open Access
Access granted
Subscription Access
Abstract
The effect of heat treatment on the microstructure, hardness and density of sintered (1129°C, 45 min) specimens of iron-base powder alloys containing 0.8 – 2.5% C, 2% Cu and additives of chromium- and molybdenum-alloyed Astaloy E iron powder is studied.
About the authors
Farhad Ostovan
Materials Synthesis and Characterization Laboratory, Institute of Advanced Technology, University Putra Malaysia, UPM Serdang
Email: petroprom2013@yandex.ru
Malaysia, Selangor
Khamirul Amin Matori
Materials Synthesis and Characterization Laboratory, Institute of Advanced Technology, University Putra Malaysia, UPM Serdang; Department of Physics, Faculty of Science, University Putra Malaysia
Email: petroprom2013@yandex.ru
Malaysia, Selangor; Serdang, Selangor
Hamdan Mohamed Yusoff
Department of Chemical and Environmental Engineering, Faculty of Engineering, University Putra Malaysia
Email: petroprom2013@yandex.ru
Malaysia, Serdang, Selangor
Robiah Yunus
Department of Chemical and Environmental Engineering, Faculty of Engineering, University Putra Malaysia
Email: petroprom2013@yandex.ru
Malaysia, Serdang, Selangor
Azmah Hanim Mohamed Ariff
Department of Mechanical and Manufacturing Engineering, Faculty of Engineering, University Putra Malaysia
Email: petroprom2013@yandex.ru
Malaysia, Serdang, Selangor
Meysam Toozandehjani
Department of Mechanical and Manufacturing Engineering, Faculty of Engineering, University Putra Malaysia
Email: petroprom2013@yandex.ru
Malaysia, Serdang, Selangor
Mohammad Reza Meschian
Department of Material Engineering, Faculty of Engineering, Islamic Azad University of Majlesi
Email: petroprom2013@yandex.ru
Iran, Islamic Republic of, Isfahan
Supplementary files
