Possibilities of the Technology of Additive Production for Making Complex-Shape Parts and Depositing Functional Coatings from Metallic Powders
- Authors: Grigor’ev S.N.1, Tarasova T.V.1
-
Affiliations:
- “STANKIN” Moscow State Technological University
- Issue: Vol 57, No 9-10 (2016)
- Pages: 579-584
- Section: 85th ANNIVERSARY OF THE “STANKIN” MOSCOW STATE ENGINEERING UNIVERSITY
- URL: https://journal-vniispk.ru/0026-0673/article/view/235175
- DOI: https://doi.org/10.1007/s11041-016-9925-7
- ID: 235175
Cite item
Abstract
The aspects of terminology, definitions and classification in the technology of additive production are considered. The principal possibility of fabrication of complex-shape parts from a refractory cobalt alloy by the method of selective laser melting and deposition of hard and wear-resistant coatings from Ti and SiC powders by coaxial laser surfacing is shown. The technological possibility of microlaser surfacing with lateral resolution about 100 μm in the production of parts from aluminum alloys is considered. The mechanisms of formation of structure in the studied alloys typical for selective laser melting, laser surfacing and microlaser surfacing are determined. The physical and mechanical properties of the alloys are investigated.
About the authors
S. N. Grigor’ev
“STANKIN” Moscow State Technological University
Email: tarasova952@mail.ru
Russian Federation, Moscow
T. V. Tarasova
“STANKIN” Moscow State Technological University
Author for correspondence.
Email: tarasova952@mail.ru
Russian Federation, Moscow
Supplementary files
