Microstructure and Mechanical Properties of Welds of Al – Mg – Si Alloys After Different Modes of Impulse Friction Stir Welding
- Authors: Kondrat’ev S.Y.1, Morozova Y.N.1,2, Golubev Y.A.1,2, Hantelmann C.2, Naumov A.A.1, Mikhailov V.G.1,2
-
Affiliations:
- St. Petersburg Polytechnic University
- Brandenburg University of Technology
- Issue: Vol 59, No 11-12 (2018)
- Pages: 697-702
- Section: Article
- URL: https://journal-vniispk.ru/0026-0673/article/view/236231
- DOI: https://doi.org/10.1007/s11041-018-0213-6
- ID: 236231
Cite item
Abstract
Welded joints of aluminum alloy 6082-T6 formed by the method of impulse friction stir welding are studied. The effect of the power and frequency of the pulses on the microstructure and mechanical properties of the welded joints is determined. Application of an additional pulse during the welding affects the surface quality and the shape of the weld, the distribution of the oxide layer and of particles of the hardening phase, and the grain size in the zone of dynamic recrystallization.
About the authors
S. Yu. Kondrat’ev
St. Petersburg Polytechnic University
Author for correspondence.
Email: petroprom2013@yandex.ru
Russian Federation, St. Petersburg
Yu. N. Morozova
St. Petersburg Polytechnic University; Brandenburg University of Technology
Email: petroprom2013@yandex.ru
Russian Federation, St. Petersburg; Cottbus
Yu. A. Golubev
St. Petersburg Polytechnic University; Brandenburg University of Technology
Email: petroprom2013@yandex.ru
Russian Federation, St. Petersburg; Cottbus
C. Hantelmann
Brandenburg University of Technology
Email: petroprom2013@yandex.ru
Germany, Cottbus
A. A. Naumov
St. Petersburg Polytechnic University
Email: petroprom2013@yandex.ru
Russian Federation, St. Petersburg
V. G. Mikhailov
St. Petersburg Polytechnic University; Brandenburg University of Technology
Email: petroprom2013@yandex.ru
Russian Federation, St. Petersburg; Cottbus
Supplementary files
