Email this article Effect of Heat Treatment Modes on the Structure and Properties of Alloy VT6 After Selective Laser Melting
- Authors: Sufiyarov V.S.1, Borisov E.V.1
-
Affiliations:
- National Technology Initiative “New Production Technologies”, Center at Peter the Great St. Petersburg Polytechnic University
- Issue: Vol 60, No 11-12 (2019)
- Pages: 745-748
- Section: Article
- URL: https://journal-vniispk.ru/0026-0673/article/view/236496
- DOI: https://doi.org/10.1007/s11041-019-00350-0
- ID: 236496
Cite item
Open Access
Access granted
Subscription Access
Abstract
The structure and mechanical properties of specimens produced by selective laser melting of a plasma-atomized powder of alloy VT6 are studied. The effect of annealing at 800 – 1050°C on the microstructure represented after the selective laser melting by a fine dispersed martensitic α′-phase and primary β-grains is considered.
About the authors
V. Sh. Sufiyarov
National Technology Initiative “New Production Technologies”, Center at Peter the Great St. Petersburg Polytechnic University
Email: evgenii.borisov@icloud.com
Russian Federation, St. Petersburg
E. V. Borisov
National Technology Initiative “New Production Technologies”, Center at Peter the Great St. Petersburg Polytechnic University
Author for correspondence.
Email: evgenii.borisov@icloud.com
Russian Federation, St. Petersburg
Supplementary files
