Email this article Accounting for the Technological History of the Formation of a Part in Strength Calculations
- Authors: Mironenko V.V.1, Polyakova O.E.1, Sechkarenko D.A.2, Kotov V.V.3
-
Affiliations:
- Irkutsk National Research Technical University
- Irkut Corporation
- Russian Representative of the ESI Group and Ural Federal University
- Issue: Vol 59, No 9-10 (2016)
- Pages: 871-876
- Section: Article
- URL: https://journal-vniispk.ru/0026-0894/article/view/237249
- DOI: https://doi.org/10.1007/s11015-016-0186-x
- ID: 237249
Cite item
Open Access
Access granted
Subscription Access
Abstract
Strength calculations are performed for a new part with allowance for the forming operations used to make it. The process of accounting for the technological history of the part in such calculations is illustrated by examining the strength design of a part in the form of a branch pipe composed of two and/or three smaller parts with welds.
About the authors
V. V. Mironenko
Irkutsk National Research Technical University
Author for correspondence.
Email: mironenko_vv@istu.edu
Russian Federation, Irkutsk
O. E. Polyakova
Irkutsk National Research Technical University
Email: mironenko_vv@istu.edu
Russian Federation, Irkutsk
D. A. Sechkarenko
Irkut Corporation
Email: mironenko_vv@istu.edu
Russian Federation, Irkutsk
V. V. Kotov
Russian Representative of the ESI Group and Ural Federal University
Email: mironenko_vv@istu.edu
Russian Federation, Ekaterinburg
Supplementary files
