Email this article Choosing a System for the Slit-Rolling of Rebars
- Authors: Starkov N.V.1, Bobarikin Y.L.2
-
Affiliations:
- Belarus Metallurgical Plant (BMZ) – Management Company of the BMK Holding
- Gomel State Technical University
- Issue: Vol 60, No 3-4 (2016)
- Pages: 384-389
- Section: Article
- URL: https://journal-vniispk.ru/0026-0894/article/view/238482
- DOI: https://doi.org/10.1007/s11015-016-0303-x
- ID: 238482
Cite item
Open Access
Access granted
Subscription Access
Abstract
Aspects of selecting the rolling regime and calculating the geometric parameters of passes used to make rebars by slit-rolling on continuous light-section mills are discussed. An example is presented of calculating the geometric parameters of the second special pass used in the slit-rolling process.
About the authors
N. V. Starkov
Belarus Metallurgical Plant (BMZ) – Management Company of the BMK Holding
Author for correspondence.
Email: starkov-nikita@rambler.ru
Belarus, Zhlobin
Yu. L. Bobarikin
Gomel State Technical University
Email: starkov-nikita@rambler.ru
Belarus, Gomel
Supplementary files
