Simulation of Rotary Piercing Process

A. A. Bogatov; D. Sh. Nukhov; V. A. Toporov

doi:10.1007/s11015-017-0460-6

Simulation of Rotary Piercing Process

Authors: Bogatov A.A.¹, Nukhov D.S.¹, Toporov V.A.²
Affiliations:
1. Ural Federal University
2. Seversky Pipe Plant
Issue: Vol 61, No 1-2 (2017)
Pages: 101-105
Section: Article
URL: https://journal-vniispk.ru/0026-0894/article/view/239931
DOI: https://doi.org/10.1007/s11015-017-0460-6
ID: 239931

Cite item

Full Text

Open Access
Restricted Access

Access granted
Restricted Access

Subscription Access

Abstract
About the authors
References
Supplementary files
Statistics

Abstract

The rotary piercing process is studied using Deform-3D software based on the finite-element method. The trajectories of points with different radial coordinates are found, and the draft is determined. The screw lead within the deformation zone is calculated. The draft, reduction, contact width, ovality, and strain are determined.