Email this article Simulation of the Conform-Type Pressing Process by Using the QFORM VX Software Complex
- Authors: Ershov A.A.1, Loginov Y.N.2
-
Affiliations:
- PLM-Ural Company Group
- Ural Federal University
- Issue: Vol 62, No 3-4 (2018)
- Pages: 207-211
- Section: Article
- URL: https://journal-vniispk.ru/0026-0894/article/view/241553
- DOI: https://doi.org/10.1007/s11015-018-0646-6
- ID: 241553
Cite item
Open Access
Access granted
Subscription Access
Abstract
On the basis of simulation with the help of the QFORM VX software, we study the CONFORM process with an aim to eliminate the delamination defects of products in the course of subsequent heat treatment. In the first stage of the solution, it is necessary to determine the stress-strain state in the deformation zone in the billet and to analyze the behavior of the flow of metal and the appearance of the zones of hindered deformation.
Keywords
About the authors
A. A. Ershov
PLM-Ural Company Group
Author for correspondence.
Email: info@plm-ural.ru
Russian Federation, Ekaterinburg
Yu. N. Loginov
Ural Federal University
Email: info@plm-ural.ru
Russian Federation, Ekaterinburg
Supplementary files
