Email this article Conditions of Air Shot Hardening of VT41 Titanium Alloy Blisk Blades for an Advanced Engine
- Authors: Yakovlev M.G.1,2, Kyaramyan K.A.1, Shirvan’yants G.G.1
-
Affiliations:
- AO NPTs Gazoturbostroeniya Salyut
- Moscow State Technological University Stankin
- Issue: Vol 2019, No 6 (2019)
- Pages: 636-639
- Section: Hardening and Coating Technologies
- URL: https://journal-vniispk.ru/0036-0295/article/view/173308
- DOI: https://doi.org/10.1134/S0036029519060181
- ID: 173308
Cite item
Open Access
Access granted
Subscription Access
Abstract
The influence of the conditions of air shot hardening on the surface quality and the fatigue resistance of blisk blades made of a high-temperature VT41 titanium alloy is studied. Flat VT41 alloy samples are analyzed to determine the optimum conditions of hardening to introduce them into the process of production of welded blisks for a high-pressure compressor (HPC) in an advanced engine. The required quality parameters of the surface layers in the samples and blades after hardening, namely, residual stresses, the degree and depth of hardening, microstructural characteristics, surface roughness, are achieved.
About the authors
M. G. Yakovlev
AO NPTs Gazoturbostroeniya Salyut; Moscow State Technological University Stankin
Author for correspondence.
Email: om-niid@salut.ru
Russian Federation, Moscow, 105118; Moscow, 127055
K. A. Kyaramyan
AO NPTs Gazoturbostroeniya Salyut
Email: om-niid@salut.ru
Russian Federation, Moscow, 105118
G. G. Shirvan’yants
AO NPTs Gazoturbostroeniya Salyut
Email: om-niid@salut.ru
Russian Federation, Moscow, 105118
Supplementary files
