Email this article Effect of Machining of the Edge of a Blank Made of a Polymer Composite Material on Its Water Resistance
- Authors: Ikhuaen’i R.C.1, Baurova N.I.1
-
Affiliations:
- Moscow Automobile and Road Construction University
- Issue: Vol 2019, No 13 (2019)
- Pages: 1483-1486
- Section: Machining of Blanks and Assembly
- URL: https://journal-vniispk.ru/0036-0295/article/view/173897
- DOI: https://doi.org/10.1134/S003602951913010X
- ID: 173897
Cite item
Open Access
Access granted
Subscription Access
Abstract
The influence of the method of machining of the edges of carbon-filled plastics on their water absorption is experimentally studied. The water absorption of composite materials is shown to depend on both the method of machining of the edges and the plastic material. The results of structural investigations demonstrate that milling is the most suitable method for machining the edges of the polymer composite material parts produced by vacuum infusion.
About the authors
R. Ch. Ikhuaen’i
Moscow Automobile and Road Construction University
Email: nbaurova@mail.ru
Russian Federation, Moscow, 125319
N. I. Baurova
Moscow Automobile and Road Construction University
Author for correspondence.
Email: nbaurova@mail.ru
Russian Federation, Moscow, 125319
Supplementary files
