Quinone based conducting redox polymers for electrical energy storage
- Authors: Emanuelsson R.1, Karlsson C.1, Huang H.1, Kosgei C.1, Strømme M.1, Sjödin M.1
-
Affiliations:
- Nanotechnology and Functional Materials, Department of Engineering Sciences, The Ångström Laboratory
- Issue: Vol 53, No 1 (2017)
- Pages: 8-15
- Section: Special Issue: X International Frumkin Symposium on Electrochemistry (Moscow, October 21–23, 2015), Part 2
- URL: https://journal-vniispk.ru/1023-1935/article/view/188371
- DOI: https://doi.org/10.1134/S1023193517010050
- ID: 188371
Cite item
Abstract
Conducting redox polymers (CRPs) constitute a promising class of materials for the development of organic matter based batteries with the potential to overcome the main limitations connected to this type of rechargeable battery systems including low conductivity and dissolution problems. In this report we show that the potential of quinones can be effectively tuned into the conducting region of polypyrrole (PPy), both in water based solutions and in acetonitrile, which is a prerequisite for profitable combination of the two units. We also present a device where both anode and cathode are made from PPy substituted with different quinone pendant groups and where good rate performance is achieved without any conductivity additives thus providing support for the hypothesized synergetic effect of a conducting polymer backbone and a covalently attached redox active pendant group. This device constitutes, to the best of our knowledge, the first all-CRP based battery reported to date.
About the authors
R. Emanuelsson
Nanotechnology and Functional Materials, Department of Engineering Sciences, The Ångström Laboratory
Email: martin.sjodin@angstrom.uu.se
Sweden, Uppsala, SE-751 21
C. Karlsson
Nanotechnology and Functional Materials, Department of Engineering Sciences, The Ångström Laboratory
Email: martin.sjodin@angstrom.uu.se
Sweden, Uppsala, SE-751 21
H. Huang
Nanotechnology and Functional Materials, Department of Engineering Sciences, The Ångström Laboratory
Email: martin.sjodin@angstrom.uu.se
Sweden, Uppsala, SE-751 21
C. Kosgei
Nanotechnology and Functional Materials, Department of Engineering Sciences, The Ångström Laboratory
Email: martin.sjodin@angstrom.uu.se
Sweden, Uppsala, SE-751 21
M. Strømme
Nanotechnology and Functional Materials, Department of Engineering Sciences, The Ångström Laboratory
Email: martin.sjodin@angstrom.uu.se
Sweden, Uppsala, SE-751 21
M. Sjödin
Nanotechnology and Functional Materials, Department of Engineering Sciences, The Ångström Laboratory
Author for correspondence.
Email: martin.sjodin@angstrom.uu.se
Sweden, Uppsala, SE-751 21
Supplementary files
