Email this article Tracking Chambers Made of Mylar Drift Tubes for Experiments at the Accelerator Complex of the National Research Center Kurchatov Institute–IHEP
- Authors: Bozhko N.I.1,2, Borisov A.A.1,2, Kozhin A.S.1,2, Fakhrutdinov R.M.1,2
-
Affiliations:
- National Research Center Kurchatov Institute
- Logunov Institute of High Energy Physics
- Issue: Vol 81, No 9 (2018)
- Pages: 1312-1317
- Section: Engineering Design of Nuclear Physics Equipment
- URL: https://journal-vniispk.ru/1063-7788/article/view/193850
- DOI: https://doi.org/10.1134/S1063778818090053
- ID: 193850
Cite item
Open Access
Access granted
Subscription Access
Abstract
The design, procedure of assembling, and tests of drift tubes with the diameter of 30 and 15 mm made of mylar film 125 μm thick covered with aluminum from both sides are presented. The assembly technology of three-layer chambers of such tubes is described and some results showing the technical performance of the chambers are given.
About the authors
N. I. Bozhko
National Research Center Kurchatov Institute; Logunov Institute of High Energy Physics
Email: Anatoly.Kozhin@mail.ihep.ru
Russian Federation, Moscow, 123182; Protvino, Moscow oblast, 142281
A. A. Borisov
National Research Center Kurchatov Institute; Logunov Institute of High Energy Physics
Email: Anatoly.Kozhin@mail.ihep.ru
Russian Federation, Moscow, 123182; Protvino, Moscow oblast, 142281
A. S. Kozhin
National Research Center Kurchatov Institute; Logunov Institute of High Energy Physics
Author for correspondence.
Email: Anatoly.Kozhin@mail.ihep.ru
Russian Federation, Moscow, 123182; Protvino, Moscow oblast, 142281
R. M. Fakhrutdinov
National Research Center Kurchatov Institute; Logunov Institute of High Energy Physics
Email: Anatoly.Kozhin@mail.ihep.ru
Russian Federation, Moscow, 123182; Protvino, Moscow oblast, 142281
Supplementary files
