Tracking Chambers Made of Mylar Drift Tubes for Experiments at the Accelerator Complex of the National Research Center Kurchatov Institute–IHEP


Citar

Texto integral

Acesso aberto Acesso aberto
Acesso é fechado Acesso está concedido
Acesso é fechado Somente assinantes

Resumo

The design, procedure of assembling, and tests of drift tubes with the diameter of 30 and 15 mm made of mylar film 125 μm thick covered with aluminum from both sides are presented. The assembly technology of three-layer chambers of such tubes is described and some results showing the technical performance of the chambers are given.

Sobre autores

N. Bozhko

National Research Center Kurchatov Institute; Logunov Institute of High Energy Physics

Email: Anatoly.Kozhin@mail.ihep.ru
Rússia, Moscow, 123182; Protvino, Moscow oblast, 142281

A. Borisov

National Research Center Kurchatov Institute; Logunov Institute of High Energy Physics

Email: Anatoly.Kozhin@mail.ihep.ru
Rússia, Moscow, 123182; Protvino, Moscow oblast, 142281

A. Kozhin

National Research Center Kurchatov Institute; Logunov Institute of High Energy Physics

Autor responsável pela correspondência
Email: Anatoly.Kozhin@mail.ihep.ru
Rússia, Moscow, 123182; Protvino, Moscow oblast, 142281

R. Fakhrutdinov

National Research Center Kurchatov Institute; Logunov Institute of High Energy Physics

Email: Anatoly.Kozhin@mail.ihep.ru
Rússia, Moscow, 123182; Protvino, Moscow oblast, 142281

Arquivos suplementares

Arquivos suplementares
Ação
1. JATS XML

Declaração de direitos autorais © Pleiades Publishing, Ltd., 2018