Preparation of V2O5 from Ammonium Metavanadate via Microwave Intensification
- Authors: Liu B.1,2,3, Peng J.1,2,3, Zhang L.1,2,3, Zhou J.1,2,3, Srinivasakannan C.4
-
Affiliations:
- State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization
- Faculty of Metallurgical and Energy Engineering
- Key Laboratory of Unconventional Metallurgy, Ministry of Education
- Chemical Engineering Department
- Issue: Vol 58, No 6 (2017)
- Pages: 600-607
- Section: Metallurgy of Rare and Noble Metals
- URL: https://journal-vniispk.ru/1067-8212/article/view/226367
- DOI: https://doi.org/10.3103/S1067821217060062
- ID: 226367
Cite item
Abstract
Parameters of technique to prepare of V2O5 by microwave intensification from ammonium metavanadate were optimized using central composite design of response surface methodology. A quadratic equation model for decomposition rate was built and effects of main factors and their corresponding relationships were obtained. The microwave heating behavior indicated that ammonium metavanadate had weak capability to absorb microwave radiation, while V2O5 had good capability to absorb microwave radiation. The results of the statistical analysis showed that the decomposition rate of ammonium metavanadate was significantly affected by calcination temperature and calcination time in the range studied. The optimized conditions were as follows: calcination temperature 645.35 K, calcination time 9.66 min and 4.3 g, respectively. The decomposition rates of ammonium metavanadate were 99.13%, which coincided well with experiments values 99.33% under these conditions. These suggest that regressive equation fits the decomposition rates perfectly. XRD reveals that it is feasible to prepare the V2O5 by microwave intensification from ammonium metavanadate, which mixed with small amounts of V2O5.
About the authors
Bingguo Liu
State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization; Faculty of Metallurgical and Energy Engineering; Key Laboratory of Unconventional Metallurgy, Ministry of Education
Email: lbzhang@kmust.edu.cn
China, Kunming, 650093; Kunming, 650093; Kunming, 650093
Jinhui Peng
State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization; Faculty of Metallurgical and Energy Engineering; Key Laboratory of Unconventional Metallurgy, Ministry of Education
Email: lbzhang@kmust.edu.cn
China, Kunming, 650093; Kunming, 650093; Kunming, 650093
Libo Zhang
State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization; Faculty of Metallurgical and Energy Engineering; Key Laboratory of Unconventional Metallurgy, Ministry of Education
Author for correspondence.
Email: lbzhang@kmust.edu.cn
China, Kunming, 650093; Kunming, 650093; Kunming, 650093
Junwen Zhou
State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization; Faculty of Metallurgical and Energy Engineering; Key Laboratory of Unconventional Metallurgy, Ministry of Education
Email: lbzhang@kmust.edu.cn
China, Kunming, 650093; Kunming, 650093; Kunming, 650093
C. Srinivasakannan
Chemical Engineering Department
Email: lbzhang@kmust.edu.cn
United Arab Emirates, Abudhabi
Supplementary files
