Email this article Resistance of titanium alloys to cutting
- Authors: Arshinov S.V.1, Gorelov V.A.2, Kushner V.S.3, Burgonova O.Y.3
-
Affiliations:
- Department of the Aviation Industry
- OAO NIID
- Omsk State Technical University
- Issue: Vol 36, No 1 (2016)
- Pages: 56-62
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/225960
- DOI: https://doi.org/10.3103/S1068798X16010044
- ID: 225960
Cite item
Open Access
Access granted
Subscription Access
Abstract
A thermomechanical model of the resistance of titanium alloys to cutting is proposed. The model takes account of the influence of the strain, strain rate, and temperature on the yield point. The maximum yield point in the chip-formation zone and at the front surface of the cutter is established. Analysis of elementary-chip formation in the turning of titanium alloys permits the determination of the temperature and cutting force.
About the authors
S. V. Arshinov
Department of the Aviation Industry
Author for correspondence.
Email: to-niid@salut.ru
Russian Federation, Moscow
V. A. Gorelov
OAO NIID
Email: to-niid@salut.ru
Russian Federation, Moscow
V. S. Kushner
Omsk State Technical University
Email: to-niid@salut.ru
Russian Federation, Omsk
O. Yu. Burgonova
Omsk State Technical University
Email: to-niid@salut.ru
Russian Federation, Omsk
Supplementary files
