Email this article Prediction of the cooling of cutting zones by means of vortex tubes in high-speed machining
- Authors: Korkodinov Y.A.1, Peshcherenko S.N.1, Esov V.B.2, Ablyaz T.R.1, Muratov K.R.1
-
Affiliations:
- Perm National Research Polytechnic University
- Bauman Moscow State Technical University
- Issue: Vol 36, No 1 (2016)
- Pages: 71-73
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/225985
- DOI: https://doi.org/10.3103/S1068798X16010123
- ID: 225985
Cite item
Open Access
Access granted
Subscription Access
Abstract
The possibility of using vortex tubes to inject cooled ionized air into the cutting zone in high-speed machining is considered. Numerical calculation of the vortex effect is employed to predict the cooling of the cutting zone. The results are compared with experimental data.
About the authors
Ya. A. Korkodinov
Perm National Research Polytechnic University
Author for correspondence.
Email: svarogjk1989@rambler.ru
Russian Federation, Perm
S. N. Peshcherenko
Perm National Research Polytechnic University
Email: svarogjk1989@rambler.ru
Russian Federation, Perm
V. B. Esov
Bauman Moscow State Technical University
Email: svarogjk1989@rambler.ru
Russian Federation, Moscow
T. R. Ablyaz
Perm National Research Polytechnic University
Email: svarogjk1989@rambler.ru
Russian Federation, Perm
K. R. Muratov
Perm National Research Polytechnic University
Email: svarogjk1989@rambler.ru
Russian Federation, Perm
Supplementary files
