Email this article Lathe turning of complex-shaped parts providing desired surface microrelief
- Authors: Grechishnikov V.A.1, Petukhov Y.E.1, Pivkin P.M.1, Isaev A.V.1, Romanov V.B.1, Domnin P.V.1
-
Affiliations:
- Stankin Moscow State Technical University
- Issue: Vol 36, No 3 (2016)
- Pages: 229-231
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/226260
- DOI: https://doi.org/10.3103/S1068798X16030059
- ID: 226260
Cite item
Open Access
Access granted
Subscription Access
Abstract
The machining of complex parts with surface shaping by different sections of the cutting edge is considered.
About the authors
V. A. Grechishnikov
Stankin Moscow State Technical University
Email: pmpivkin@gmail.com
Russian Federation, Moscow
Yu. E. Petukhov
Stankin Moscow State Technical University
Email: pmpivkin@gmail.com
Russian Federation, Moscow
P. M. Pivkin
Stankin Moscow State Technical University
Author for correspondence.
Email: pmpivkin@gmail.com
Russian Federation, Moscow
A. V. Isaev
Stankin Moscow State Technical University
Email: pmpivkin@gmail.com
Russian Federation, Moscow
V. B. Romanov
Stankin Moscow State Technical University
Email: pmpivkin@gmail.com
Russian Federation, Moscow
P. V. Domnin
Stankin Moscow State Technical University
Email: pmpivkin@gmail.com
Russian Federation, Moscow
Supplementary files
