Email this article Tool system for high-speed milling
- Authors: Maslov A.R.1
-
Affiliations:
- Stankin Moscow State Technical University
- Issue: Vol 36, No 3 (2016)
- Pages: 232-234
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/226269
- DOI: https://doi.org/10.3103/S1068798X16030138
- ID: 226269
Cite item
Open Access
Access granted
Subscription Access
Abstract
A model of the tool system for the high-speed milling of high-technology components is developed. The influence of the dimensions of the system components on the roughness of the machined surface is studied. The formulas obtained permit assessment of the milling productivity for the dimensional parameters of the tool system and the roughness, specified for a specific technological process.
About the authors
A. R. Maslov
Stankin Moscow State Technical University
Author for correspondence.
Email: vestnik@stankin.ru
Russian Federation, Moscow
Supplementary files
