Email this article Abrasive-jet machining of large hollow components
- Authors: Zakharov O.V.1, Khudobin L.V.2, Vetkasov N.I.2, Sklyarov I.A.2, Kochetkov A.V.3
-
Affiliations:
- Institute of Precision Mechanics and Control of Russian Academy of Sciences
- Ul’yanovsk State Technical University
- Perm National Research Polytechnic University
- Issue: Vol 36, No 6 (2016)
- Pages: 469-471
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/226643
- DOI: https://doi.org/10.3103/S1068798X16060228
- ID: 226643
Cite item
Open Access
Access granted
Subscription Access
Abstract
Analytical formulas are derived for the internal surface characteristics of a large cylindrical workpiece after treatment by an abrasive–air jet as a function of the machining conditions. A formula for the productivity is also presented.
About the authors
O. V. Zakharov
Institute of Precision Mechanics and Control of Russian Academy of Sciences
Author for correspondence.
Email: zov17@mail.ru
Russian Federation, Moscow
L. V. Khudobin
Ul’yanovsk State Technical University
Email: zov17@mail.ru
Russian Federation, Ul’yanovsk
N. I. Vetkasov
Ul’yanovsk State Technical University
Email: zov17@mail.ru
Russian Federation, Ul’yanovsk
I. A. Sklyarov
Ul’yanovsk State Technical University
Email: zov17@mail.ru
Russian Federation, Ul’yanovsk
A. V. Kochetkov
Perm National Research Polytechnic University
Email: zov17@mail.ru
Russian Federation, Perm
Supplementary files
