Email this article Burnishing with wear-resistant mineral–ceramic and hard-alloy indenters
- Authors: Gadalov V.N.1, Gvozdev A.E.2, Romanenko D.N.1, Vornacheva I.V.1, Kovalev S.V.3
-
Affiliations:
- Southwest State University
- Tolstoi Tula State Polytechnic University
- Ivanov Kursk State Agricultural Academy
- Issue: Vol 36, No 9 (2016)
- Pages: 731-734
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/226986
- DOI: https://doi.org/10.3103/S1068798X16090082
- ID: 226986
Cite item
Open Access
Access granted
Subscription Access
Abstract
Means of increasing the wear resistance of burnishing tools with mineral–ceramic and hard-alloy indenters are considered. Indenter designs that optimize the cost and quality of burnishing by means of a rigidly attached tool are discussed.
Keywords
About the authors
V. N. Gadalov
Southwest State University
Email: vornairina2008@yandex.ru
Russian Federation, Kursk
A. E. Gvozdev
Tolstoi Tula State Polytechnic University
Email: vornairina2008@yandex.ru
Russian Federation, Tula
D. N. Romanenko
Southwest State University
Email: vornairina2008@yandex.ru
Russian Federation, Kursk
I. V. Vornacheva
Southwest State University
Author for correspondence.
Email: vornairina2008@yandex.ru
Russian Federation, Kursk
S. V. Kovalev
Ivanov Kursk State Agricultural Academy
Email: vornairina2008@yandex.ru
Russian Federation, Kursk
Supplementary files
