Email this article Behavior of heat-resistant alloys and titanium alloys on cutting
- Authors: Petukhov G.D.1, Makarov V.F.1
-
Affiliations:
- Perm National Research Polytechnic
- Issue: Vol 36, No 9 (2016)
- Pages: 741-744
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/226995
- DOI: https://doi.org/10.3103/S1068798X16090173
- ID: 226995
Cite item
Open Access
Access granted
Subscription Access
Abstract
The properties of heat-resistant alloys used for the manufacture of compressor blades are analyzed. The optimal cutting speeds for titanium alloys and heat-resistant alloys are determined. The dependence of the plastic strain and chip formation on the cutting speed in the broaching of such alloys is established.
Keywords
About the authors
G. D. Petukhov
Perm National Research Polytechnic
Author for correspondence.
Email: e1190980@yandex.ru
Russian Federation, Perm
V. F. Makarov
Perm National Research Polytechnic
Email: e1190980@yandex.ru
Russian Federation, Perm
Supplementary files
