Email this article Longitudinal–transverse extrusion of hollow components from bar
- Authors: Danilin G.A.1, Filin D.S.1, Volzhin S.G.2
-
Affiliations:
- Ustinov Voenmekh Baltic State Technical University
- OAO Tul’skii Patronnyi Zavod
- Issue: Vol 36, No 10 (2016)
- Pages: 836-840
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227055
- DOI: https://doi.org/10.3103/S1068798X16100075
- ID: 227055
Cite item
Open Access
Access granted
Subscription Access
Abstract
The longitudinal–transverse extrusion of hollow components from bar is studied. Strength assessment of the blank is discussed. In view of the stress–strain state of the blanks, limits must be imposed on the process in order to maintain the strength of the lateral surface and prevent critical loads on the tool.
About the authors
G. A. Danilin
Ustinov Voenmekh Baltic State Technical University
Author for correspondence.
Email: bgtu_e4@mail.ru
Russian Federation, St. Petersburg
D. S. Filin
Ustinov Voenmekh Baltic State Technical University
Email: bgtu_e4@mail.ru
Russian Federation, St. Petersburg
S. G. Volzhin
OAO Tul’skii Patronnyi Zavod
Email: bgtu_e4@mail.ru
Russian Federation, Tula
Supplementary files
