Email this article Single-turn worm mills for conical round-tooth gears
- Authors: Kondrashov A.G.1, Safarov D.T.1, Faskhutdinov A.I.1, Davletshina G.K.1
-
Affiliations:
- Naberezhnye Chelny Institute
- Issue: Vol 37, No 9 (2017)
- Pages: 812-813
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227146
- DOI: https://doi.org/10.3103/S1068798X17090143
- ID: 227146
Cite item
Open Access
Access granted
Subscription Access
Abstract
Facets must be machined at the end of gear teeth. The shaping of facets by single-turn worm mills is considered in detail. Deficiencies are found in familiar design methods for such mills. Formulas are proposed for the calculation of single-turn worm mills used in machining conical round-tooth gears.
About the authors
A. G. Kondrashov
Naberezhnye Chelny Institute
Author for correspondence.
Email: kondrashovag@mail.ru
Russian Federation, Naberezhnye Chelny
D. T. Safarov
Naberezhnye Chelny Institute
Email: kondrashovag@mail.ru
Russian Federation, Naberezhnye Chelny
A. I. Faskhutdinov
Naberezhnye Chelny Institute
Email: kondrashovag@mail.ru
Russian Federation, Naberezhnye Chelny
G. K. Davletshina
Naberezhnye Chelny Institute
Email: kondrashovag@mail.ru
Russian Federation, Naberezhnye Chelny
Supplementary files
