Email this article Trochoidal slot milling
- Authors: Grechishnikov V.A.1, Petukhov Y.E.1, Pivkin P.M.1, Romanov V.B.1, Ryabov E.A.2, Yurasov S.Y.2, Yurasova O.I.2
-
Affiliations:
- Stankin Moscow State Technical University
- Naberezhnye Chelny Institute
- Issue: Vol 37, No 9 (2017)
- Pages: 821-823
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227149
- DOI: https://doi.org/10.3103/S1068798X17090106
- ID: 227149
Cite item
Open Access
Access granted
Subscription Access
Abstract
Parameter specification in the trochoidal machining of a slot of constant width is considered. A formula is proposed for the displacement increment of the shaping circle as a function of the cutting depth.
About the authors
V. A. Grechishnikov
Stankin Moscow State Technical University
Author for correspondence.
Email: v.grechishnikov@stankin.ru
Russian Federation, Moscow
Yu. E. Petukhov
Stankin Moscow State Technical University
Email: docfile@yandex.ru
Russian Federation, Moscow
P. M. Pivkin
Stankin Moscow State Technical University
Email: docfile@yandex.ru
Russian Federation, Moscow
V. B. Romanov
Stankin Moscow State Technical University
Email: docfile@yandex.ru
Russian Federation, Moscow
E. A. Ryabov
Naberezhnye Chelny Institute
Author for correspondence.
Email: docfile@yandex.ru
Russian Federation, Naberezhnye Chelny
S. Yu. Yurasov
Naberezhnye Chelny Institute
Email: docfile@yandex.ru
Russian Federation, Naberezhnye Chelny
O. I. Yurasova
Naberezhnye Chelny Institute
Email: docfile@yandex.ru
Russian Federation, Naberezhnye Chelny
Supplementary files
