Email this article Wear resistance of hard-alloy disk mills with different flank geometry
- Authors: Kovelenov N.Y.1, Bolotskikh S.V.1, Mikhailov S.V.2, Mikhailov A.S.2
-
Affiliations:
- OOO Virial
- Kostroma State Technological University
- Issue: Vol 37, No 2 (2017)
- Pages: 144-147
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227237
- DOI: https://doi.org/10.3103/S1068798X17020125
- ID: 227237
Cite item
Open Access
Access granted
Subscription Access
Abstract
A method for comparing the wear resistance of disk mills with different flank geometry is outlined. Hard-alloy disk mills with a curvilinear flank surface characterized by improved wear resistance are developed. Test results are presented for disk mills with different flank sharpening.
About the authors
N. Yu. Kovelenov
OOO Virial
Author for correspondence.
Email: info@virial.ru
Russian Federation, St. Petersburg
S. V. Bolotskikh
OOO Virial
Email: michsv@yandex.ru
Russian Federation, St. Petersburg
S. V. Mikhailov
Kostroma State Technological University
Author for correspondence.
Email: michsv@yandex.ru
Russian Federation, Kostroma
A. S. Mikhailov
Kostroma State Technological University
Email: michsv@yandex.ru
Russian Federation, Kostroma
Supplementary files
