Email this article Selection of metal-cutting machines in operational design by means of PLM systems
- Authors: Krestyaninov P.N.1, Khusainov R.M.1, Yurasov S.Y.1, Grechishnikov V.A.2, Romanov V.B.2
-
Affiliations:
- Naberezhnye Chelny Institute
- Stankin Moscow State Technological University
- Issue: Vol 37, No 3 (2017)
- Pages: 233-237
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227254
- DOI: https://doi.org/10.3103/S1068798X17030133
- ID: 227254
Cite item
Open Access
Access granted
Subscription Access
Abstract
A method is proposed for the selection of metal-cutting machines in the design of technological operations using Teamcenter and UNIGRAPHICS NX software.
Keywords
About the authors
P. N. Krestyaninov
Naberezhnye Chelny Institute
Email: rmh@inbox.ru
Russian Federation, Naberezhnye Chelny
R. M. Khusainov
Naberezhnye Chelny Institute
Author for correspondence.
Email: rmh@inbox.ru
Russian Federation, Naberezhnye Chelny
S. Yu. Yurasov
Naberezhnye Chelny Institute
Email: rmh@inbox.ru
Russian Federation, Naberezhnye Chelny
V. A. Grechishnikov
Stankin Moscow State Technological University
Email: rmh@inbox.ru
Russian Federation, Moscow
V. B. Romanov
Stankin Moscow State Technological University
Email: rmh@inbox.ru
Russian Federation, Moscow
Supplementary files
