Email this article Improved Smoothing by a Tool with Ceramic Inserts
- Authors: Puchkin V.N.1, Ryzhkin A.A.2, Kokhanovskii V.A.2, Kashcheeva T.V.3, Storozhenko I.D.3
-
Affiliations:
- Armavir Mechanical and Technological Institute
- Don State Technical University
- Kuban State Technical University
- Issue: Vol 38, No 2 (2018)
- Pages: 126-129
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227389
- DOI: https://doi.org/10.3103/S1068798X18020144
- ID: 227389
Cite item
Open Access
Access granted
Subscription Access
Abstract
A dynamic system is analyzed by the simulation of two subsystems (for the part and the tool) that interact through the dynamic link formed by the machining process. This link corresponds to the smoothing forces, which may be expressed in terms of the state of the dynamic system. The dynamic stability and behavior of the system are expressed in terms of displacements from equilibrium.
About the authors
V. N. Puchkin
Armavir Mechanical and Technological Institute
Email: vanyatka_2007@mail.ru
Russian Federation, Armavir
A. A. Ryzhkin
Don State Technical University
Email: vanyatka_2007@mail.ru
Russian Federation, Rostov-on-Don
V. A. Kokhanovskii
Don State Technical University
Email: vanyatka_2007@mail.ru
Russian Federation, Rostov-on-Don
T. V. Kashcheeva
Kuban State Technical University
Email: vanyatka_2007@mail.ru
Russian Federation, Krasnodar
I. D. Storozhenko
Kuban State Technical University
Author for correspondence.
Email: vanyatka_2007@mail.ru
Russian Federation, Krasnodar
Supplementary files
