Email this article Machining by End Mills with Overlapping Cutter–Workpiece Contacts
- Authors: Gubanova A.A.1
-
Affiliations:
- Don State Technical University
- Issue: Vol 38, No 9 (2018)
- Pages: 714-716
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227525
- DOI: https://doi.org/10.3103/S1068798X18090149
- ID: 227525
Cite item
Open Access
Access granted
Subscription Access
Abstract
This study addresses the influence of cutting forces and mill deformation on the surface quality obtained in machining. A mathematical model is proposed for calculating the trajectory of mill deformation in the shaped surface. Tests confirm the adequacy of the model.
Keywords
About the authors
A. A. Gubanova
Don State Technical University
Author for correspondence.
Email: anatoliya81@mail.ru
Russian Federation, Rostov-on-Don
Supplementary files
