Chip Formation in Turning by Cutting Inserts with Balls at the Front Surface

A. A. Malikov; S. A. Vasin; L. A. Vasin; E. V. Plakhotnikova

doi:10.3103/S1068798X18110084

Chip Formation in Turning by Cutting Inserts with Balls at the Front Surface

Authors: Malikov A.A.¹, Vasin S.A.¹, Vasin L.A.¹, Plakhotnikova E.V.¹
Affiliations:
1. Tula State University
Issue: Vol 38, No 11 (2018)
Pages: 879-881
Section: Article
URL: https://journal-vniispk.ru/1068-798X/article/view/227566
DOI: https://doi.org/10.3103/S1068798X18110084
ID: 227566

Cite item

Full Text

Open Access
Restricted Access

Access granted
Restricted Access

Subscription Access

Abstract
About the authors
References
Supplementary files
Statistics

Abstract

The chip formation in turning by cutting inserts with balls at the front surface is considered. Chip samples are shown. The use of such cutting inserts is found to decrease vibration in the lathe and to improve the final surface quality.

Keywords

turning, cutting tools, chip disintegration, cutting inserts, vibrational stability, emergent properties

About the authors

A. A. Malikov

Tula State University

Author for correspondence.
Email: tppizi@yandex.ru
Russian Federation, Tula

S. A. Vasin

Tula State University

Author for correspondence.
Email: vasin_sa53@mail.ru
Russian Federation, Tula

L. A. Vasin

Tula State University

Email: e_plahotnikova@mail.ru
Russian Federation, Tula

E. V. Plakhotnikova

Tula State University

Author for correspondence.
Email: e_plahotnikova@mail.ru
Russian Federation, Tula

Supplementary files

Supplementary Files

Action

1. JATS XML

Download

Username
Password
Remember me

Forgot password?	Register

Username
Password
Remember me

Forgot password?	Register