Temperature Rise in the Cutting Zone during the High-Speed Milling of Heat-Resistant Alloys

Authors: Stramtsova E.S.¹, Albagachiev A.Y.², Preobrazhenskaya E.V.¹, Krasko A.S.¹
Affiliations:
1. Moscow Technological University
2. Moscow Technological University, Institute of Mechanical Engineering, Russian Academy of Sciences
Issue: Vol 38, No 12 (2018)
Pages: 1009-1011
Section: Article
URL: https://journal-vniispk.ru/1068-798X/article/view/227593
DOI: https://doi.org/10.3103/S1068798X18120031
ID: 227593

Cite item

Full Text

Open Access

Open Access
Restricted Access

Restricted Access

Access granted
Restricted Access

Restricted Access

Subscription Access

Abstract
About the authors
References
Supplementary files
Statistics

Abstract

The temperature rise in the cutting zone during high-speed milling is considered. A method of calculating this temperature rise is proposed.

Keywords

high-speed milling, heat-resistant alloys, cutting zone, temperature variation

About the authors

E. S. Stramtsova

Moscow Technological University

Email: albagachiev@yandex.ru
Russian Federation, Moscow

A. Yu. Albagachiev

Moscow Technological University, Institute of Mechanical Engineering, Russian Academy of Sciences

Author for correspondence.
Email: albagachiev@yandex.ru
Russian Federation, Moscow

E. V. Preobrazhenskaya

Moscow Technological University

Email: albagachiev@yandex.ru
Russian Federation, Moscow

A. S. Krasko

Moscow Technological University

Email: albagachiev@yandex.ru
Russian Federation, Moscow

Supplementary files

Supplementary Files

Action

1. JATS XML

Copyright (c) 2018 Allerton Press, Inc.

TOP