Email this article Applicability of Tractional Electric Motors
- Authors: Pautov G.A.1, Grechishnikov V.A.2, Yurasova O.I.1, Yurasov S.Y.1, Medvedeva E.M.1
-
Affiliations:
- Naberezhnye Chelny Institute, Kazan Federal University
- Stankin Moscow State Technical University
- Issue: Vol 38, No 12 (2018)
- Pages: 1026-1028
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227598
- DOI: https://doi.org/10.3103/S1068798X18120134
- ID: 227598
Cite item
Open Access
Access granted
Subscription Access
Abstract
The practicality of three armature designs for tractional electric motors (power 560–755 kW, tractional force 5326 kgf) is analyzed. The use of an armature shaft of variable (reinforced) cross section in place of the armature with a sleeve is proposed, and suggestions are made regarding the assembly of the bearings. Reinforcement of the working shaft by smoothing may be recommended.
About the authors
G. A. Pautov
Naberezhnye Chelny Institute, Kazan Federal University
Email: docfile@yandex.ru
Russian Federation, Kazan
V. A. Grechishnikov
Stankin Moscow State Technical University
Author for correspondence.
Email: ittf.stankin@gmail.com
Russian Federation, Moscow
O. I. Yurasova
Naberezhnye Chelny Institute, Kazan Federal University
Author for correspondence.
Email: yurasova-olya@yandex.ru
Russian Federation, Kazan
S. Yu. Yurasov
Naberezhnye Chelny Institute, Kazan Federal University
Author for correspondence.
Email: docfile@yandex.ru
Russian Federation, Kazan
E. M. Medvedeva
Naberezhnye Chelny Institute, Kazan Federal University
Email: docfile@yandex.ru
Russian Federation, Kazan
Supplementary files
