Email this article Surface Quality of AMg2 Aluminum Alloy with Ultrafine Grain Structure after Machining. 1. Turning
- Authors: Filippov A.V.1, Tarasov S.Y.1, Shamarin N.N.1, Podgornykh O.A.1, Filippova E.O.1
-
Affiliations:
- Tomsk Polytechnic University
- Issue: Vol 38, No 12 (2018)
- Pages: 1067-1070
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227608
- DOI: https://doi.org/10.3103/S1068798X18120249
- ID: 227608
Cite item
Open Access
Access granted
Subscription Access
Abstract
The influence of cutting on the surface roughness and undulation of AMg2 aluminum alloy with regular and ultrafine grain structure is considered. The quantitative influence of profile filters on its surface roughness and undulation is established, on the basis of 2D parameters. In the machining of materials with ultrafine grain structure, the surface quality is better than for materials with regular grain structure.
About the authors
A. V. Filippov
Tomsk Polytechnic University
Author for correspondence.
Email: avf@tpu.ru
Russian Federation, Tomsk
S. Yu. Tarasov
Tomsk Polytechnic University
Email: avf@tpu.ru
Russian Federation, Tomsk
N. N. Shamarin
Tomsk Polytechnic University
Email: avf@tpu.ru
Russian Federation, Tomsk
O. A. Podgornykh
Tomsk Polytechnic University
Email: avf@tpu.ru
Russian Federation, Tomsk
E. O. Filippova
Tomsk Polytechnic University
Email: avf@tpu.ru
Russian Federation, Tomsk
Supplementary files
