Email this article Face Turning of Holes
- Authors: Mukanov R.B.1, Kasenov A.Z.1, Itybaeva G.T.1, Musina Z.K.1, Abishev K.K.1, Bykov P.O.1
-
Affiliations:
- Toraighyrov Pavlodar State University
- Issue: Vol 39, No 1 (2019)
- Pages: 75-78
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227631
- DOI: https://doi.org/10.3103/S1068798X19010064
- ID: 227631
Cite item
Open Access
Access granted
Subscription Access
Abstract
The article presents a design for a tool block. The cutters of the tool block are located asymmetrically. Cutters carry out butt-end turning of holes. The tool block has a high durability, makes it possible to produce shallow bores with flat bottoms, increases manufacturing capability and precision, and reduces the form of deviation and asperity of a finished surface.
About the authors
R. B. Mukanov
Toraighyrov Pavlodar State University
Author for correspondence.
Email: ruslangr82@mail.ru
Kazakhstan, Pavlodar, 140008
A. Zh. Kasenov
Toraighyrov Pavlodar State University
Author for correspondence.
Email: asylbek_kasenov@mail.ru
Kazakhstan, Pavlodar, 140008
G. T. Itybaeva
Toraighyrov Pavlodar State University
Author for correspondence.
Email: galia-itibaeva@mail.ru
Kazakhstan, Pavlodar, 140008
Zh. K. Musina
Toraighyrov Pavlodar State University
Author for correspondence.
Email: mussina_zhanara@mail.ru
Kazakhstan, Pavlodar, 140008
K. K. Abishev
Toraighyrov Pavlodar State University
Author for correspondence.
Email: a.kairatolla@mail.ru
Kazakhstan, Pavlodar, 140008
P. O. Bykov
Toraighyrov Pavlodar State University
Author for correspondence.
Email: bykov_petr@mail.ru
Kazakhstan, Pavlodar, 140008
Supplementary files
