Email this article Surface Roughness in the Machining of F-4K20 Composite
- Authors: Tokarev D.I.1, Drozdov A.A.1, Gulyaev M.N.1, Sirotenko L.D.1, Islamov V.F.2, Muratov K.R.1, Ablyaz T.R.1
-
Affiliations:
- Perm National Research Polytechnic University
- OOO Kedron
- Issue: Vol 39, No 2 (2019)
- Pages: 167-170
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227653
- DOI: https://doi.org/10.3103/S1068798X19020126
- ID: 227653
Cite item
Open Access
Access granted
Subscription Access
Abstract
The influence of the machining conditions (cutting depth, cutting speed, and supply) on the surface roughness of an F-4K20 composite plate in turning by a cutter based on CVD diamond is studied. An empirical model permits calculation of the height of the surface irregularity as a function of the machining conditions. The results have been employed in production conditions.
About the authors
D. I. Tokarev
Perm National Research Polytechnic University
Author for correspondence.
Email: den.tokarev.201@yandex.ru
Russian Federation, Perm
A. A. Drozdov
Perm National Research Polytechnic University
Author for correspondence.
Email: dron.perm@mail.ru
Russian Federation, Perm
M. N. Gulyaev
Perm National Research Polytechnic University
Author for correspondence.
Email: gulyaev.maks@yandex.ru
Russian Federation, Perm
L. D. Sirotenko
Perm National Research Polytechnic University
Author for correspondence.
Email: sirotenko@pstu.ru
Russian Federation, Perm
V. F. Islamov
OOO Kedron
Author for correspondence.
Email: ivf@kedron.ru
Russian Federation, Perm
K. R. Muratov
Perm National Research Polytechnic University
Author for correspondence.
Email: karimur_80@mail.ru
Russian Federation, Perm
T. R. Ablyaz
Perm National Research Polytechnic University
Email: karimur_80@mail.ru
Russian Federation, Perm
Supplementary files
