Email this article Influence of Autoclave Molding Modes and Stack Structure on Porosity of Composite Materials
- Authors: Batrakov V.V.1, Petrushenko R.Y.1, Konstantinov D.Y.1, Khamidullin O.L.1
-
Affiliations:
- Tupolev Kazan National Research Technical University
- Issue: Vol 61, No 1 (2018)
- Pages: 90-94
- Section: Aircraft Production Technology
- URL: https://journal-vniispk.ru/1068-7998/article/view/230421
- DOI: https://doi.org/10.3103/S1068799818010142
- ID: 230421
Cite item
Open Access
Access granted
Subscription Access
Abstract
Influence of stack structure on porosity of composite materials at different modes of autoclave molding was studied. To reduce porosity of composite materials, specific stack structure and molding mode are recommended.
Keywords
About the authors
V. V. Batrakov
Tupolev Kazan National Research Technical University
Author for correspondence.
Email: pla.kai@mail.ru
Russian Federation, ul. Karla Marksa 10, Kazan Tatarstan, 420111
R. Yu. Petrushenko
Tupolev Kazan National Research Technical University
Email: pla.kai@mail.ru
Russian Federation, ul. Karla Marksa 10, Kazan Tatarstan, 420111
D. Yu. Konstantinov
Tupolev Kazan National Research Technical University
Email: pla.kai@mail.ru
Russian Federation, ul. Karla Marksa 10, Kazan Tatarstan, 420111
O. L. Khamidullin
Tupolev Kazan National Research Technical University
Email: pla.kai@mail.ru
Russian Federation, ul. Karla Marksa 10, Kazan Tatarstan, 420111
Supplementary files
