Email this article 
The pairing of a swirling spillway to the lower pool through the thrown jets
- Authors: Ponomarev N.K1, Schesnyak L.E1
-
Affiliations:
- Peoples’ Friendship University of Russia (RUDN University)
- Issue: Vol 14, No 2 (2018)
- Pages: 142-153
- Section: Mechanics of liquids
- URL: https://journal-vniispk.ru/1815-5235/article/view/346311
- DOI: https://doi.org/10.22363/1815-5235-2018-14-2-142-153
- ID: 346311
Cite item
Full Text
Abstract
In the modern practice of hydraulic engineering pressure hydrosystems reach H ≥ 200 m. In these conditions the most efficient spillway structure is the vortex shaft spillway. In this paper, the authors consider the conjugation of the swirled flow at the outlet of the discharge conduit with downstreem by thrown jet with a residual twist. In the scheme with jet drop, the residual twist of the flow during the release from the vortex spillway contributes to the expansion of the jet in the air, reducing the specific flow rate, as well as reducing the dynamic loads on the lower bed. The comparison with the jet thrown from the sock of the drainage dam at the same speed parameters (i.e. at the speed of 20-25 m/s on the lip) is carried out. The formula obtained is simple enough to determine the planned outline of the discarded jet. The scheme of conjugation of the jet with the surface of the lower tail water, as well as the calculation scheme to determine the specific discharge of the downward swirling jet.
About the authors
Nikolaj K Ponomarev
Peoples’ Friendship University of Russia (RUDN University)
Author for correspondence.
Email: ponomarev_nk@rudn.university
Candidate of Technical Science, Professor of Department of Architecture and Civil Engineering, Peoples' Friendship University of Russia (RUDN University). Scientific interests: hydraulics of structures, river hydraulics, problems of water resources
6 Miklukho-Maklaya St., Moscow, 117198, Russian FederationLeonid E Schesnyak
Peoples’ Friendship University of Russia (RUDN University)
Email: schesnyak_le@rudn.university
PhD Student of Department of Architecture and Civil Engineering, Peoples' Friendship University of Russia (RUDN University). Scientific interests: hydraulics of structures, river hydraulics
6 Miklukho-Maklaya St., Moscow, 117198, Russian FederationReferences
- Zhivotovsky B.A. Spillway and the interfacing facilities with the spin-current. M.: PFUR Publ., 1995.
- Slaski S.M. Hydraulic analysis of high pressure hydraulic engineering structures. Moscow: Energy, 1979.
- Volshanik V.V., Zuykov A.L., Mordasov A.P. Swirling flows in hydraulic structures. Moscow: Energoizdat, 1990.
- Shchukin V.K., Khalatov A.A. Heat exchange, mass transfer and hydrodynamics of swirling-tion flows in axisymmetric channels. M.: Mechanical Engineering, 1982.
- A. H. Algifri, R. K. Bhardwaj, Y. V. N. Rao. (December 1988). Eddy viscosity in decaying swirl flow in a pipe. Journal Applied Scientific Research, Springer Netherlands, Vol. 45, No 4.
- Osami Kitoh. (1991). Experimental study of turbulent swirling flow in a straight pipe. Journal of Fluid Mechanics, Cambridge University Press, Vol. 225.
- Yasutoshi Senoo, Nagata Tetuzou. (1990). Vortex flow in long pipes with different roughness. Bulletin of JSME (the Japan Society of Mechanical Engineers) [Journal Detail], 15 (90), p. 1514–1521.
- Lunati, M.E., Novikov I.S. (1995). To the question about the determination of hydraulic characteristics of spillway structures with the swirling flow. NTA Energoprogress, Journal of Hydraulic Engineering, No 9.
- Guidelines for the calculation of high-pressure vortex spillways. M.: Soushi-provokes, 1984.
- Krivchenko A.C., Ostroumov S.N. A water discharge device for pressure waterretaining structures // Byulleten' izobretenii (BI) [Bulletin of inventions (BI)], 1970, No. 17.
- Hydraulic calculations of spillway hydraulic structures. A special allowance. Moscow: Energoatomizdat, 1987.
Supplementary files
