Study of the Adhesive Properties of a Coating Prepared by Deforamtion Cladding with a Flexible Tool

M. A. Levantsevich; N. N. Maksimchenko; A. N. Belyi; R. R. Dema; V. I. Kadoshnikov; S. P. Nefed’ev; M. V. Kharchenko; R. N. Amirov; M. S. Razumov; V. I. Serebrovskii

doi:10.1007/s10556-017-0270-5

Study of the Adhesive Properties of a Coating Prepared by Deforamtion Cladding with a Flexible Tool

Authors: Levantsevich M.A.¹, Maksimchenko N.N.¹, Belyi A.N.², Dema R.R.³, Kadoshnikov V.I.³, Nefed’ev S.P.³, Kharchenko M.V.³, Amirov R.N.³, Razumov M.S.⁴, Serebrovskii V.I.⁵
Affiliations:
1. Joint Institute of Engineering, Belarus National Academy of Sciences
2. Belarus National Technical University
3. Magnitogorsk State Technical University
4. Southwest State University
5. Kursk State Agricultural Academy
Issue: Vol 52, No 11-12 (2017)
Pages: 779-784
Section: Article
URL: https://journal-vniispk.ru/0009-2355/article/view/235199
DOI: https://doi.org/10.1007/s10556-017-0270-5
ID: 235199

Cite item

Full Text

Open Access
Restricted Access

Access granted
Restricted Access

Subscription Access

Abstract
About the authors
References
Supplementary files
Statistics

Abstract

Results are given for quantitative evaluation of the adhesive strength of a coating formed by deformation cladding with a flexible tool. It is established that ultimate strength with normal separation of a specimen from an antifriction material coating formed on a steel 45 (HRC 43–45) surface reaches 7.8 MPa on average. Failure is predominantly adhesive in nature.