Email this article Modeling and Investigation of the Stability of a Multicutter Turning Process by a Trace
- Authors: Gouskov A.M.1,2, Guskov M.A.3, Tung D.D.2, Panovko G.Y.1,2
-
Affiliations:
- Blagonravov Institute of Machines Science
- Bauman Moscow State Technical University
- Le laboratoire Procédés et Ingénierie en Mécanique et Matériaux
- Issue: Vol 47, No 4 (2018)
- Pages: 317-323
- Section: Mechanics of Machines
- URL: https://journal-vniispk.ru/1052-6188/article/view/193908
- DOI: https://doi.org/10.3103/S1052618818040052
- ID: 193908
Cite item
Open Access
Access granted
Subscription Access
Abstract
The results of modeling and investigation of the stability of a continuous multicutter turning process are presented. The mathematical modeling is based on an equation for the formation of new surfaces, on equations of motion, and on the fractional-rational cutting law. The influence of the parameters of the technological system on the stability of the continuous cutting mode is analyzed.
About the authors
A. M. Gouskov
Blagonravov Institute of Machines Science; Bauman Moscow State Technical University
Author for correspondence.
Email: gouskov_am@mail.ru
Russian Federation, Moscow, 101990; Moscow, 105005
M. A. Guskov
Le laboratoire Procédés et Ingénierie en Mécanique et Matériaux
Email: gouskov_am@mail.ru
France, Paris
Dinh Dyk Tung
Bauman Moscow State Technical University
Email: gouskov_am@mail.ru
Russian Federation, Moscow, 105005
G. Ya. Panovko
Blagonravov Institute of Machines Science; Bauman Moscow State Technical University
Email: gouskov_am@mail.ru
Russian Federation, Moscow, 101990; Moscow, 105005
Supplementary files
