Email this article Machining polymer workpieces on a lathe after preliminary surface deformation
- Authors: Erenkov O.Y.1, Vereshchagina A.S.1, Kravchenko E.G.1, Kozlova M.A.1
-
Affiliations:
- Komsomolsk-on-Amur State Technical University
- Issue: Vol 36, No 5 (2016)
- Pages: 376-378
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/226483
- DOI: https://doi.org/10.3103/S1068798X1605004X
- ID: 226483
Cite item
Open Access
Access granted
Subscription Access
Abstract
Preliminary surface deformation (rolling) is proposed in the turning of polymers. The dependence of the surface roughness on the rolling and cutting conditions is derived.
Keywords
About the authors
O. Yu. Erenkov
Komsomolsk-on-Amur State Technical University
Author for correspondence.
Email: erenkov@list.ru
Russian Federation, Komsomolsk, 681013
A. S. Vereshchagina
Komsomolsk-on-Amur State Technical University
Email: erenkov@list.ru
Russian Federation, Komsomolsk, 681013
E. G. Kravchenko
Komsomolsk-on-Amur State Technical University
Email: erenkov@list.ru
Russian Federation, Komsomolsk, 681013
M. A. Kozlova
Komsomolsk-on-Amur State Technical University
Email: erenkov@list.ru
Russian Federation, Komsomolsk, 681013
Supplementary files
