Email this article Spark plasma sintering of cutting plates
- Authors: Yushin D.I.1, Smirnov A.V.1, Solis Pinargote N.1, Peretyagin P.Y.1, Kuznetsov V.A.2, Torrecillas R.1,3
-
Affiliations:
- Stankin Moscow State Technical University
- Moscow Statel University of Mechanical Engineering (MAMI)
- Centro de Investigación en Nanomateriales y Nanotecnologia (CINN)
- Issue: Vol 36, No 5 (2016)
- Pages: 410-413
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/226564
- DOI: https://doi.org/10.3103/S1068798X16050233
- ID: 226564
Cite item
Open Access
Access granted
Subscription Access
Abstract
Numerical modeling of the spark plasma sintering of square plates from aluminum-oxide and tungsten-carbide powder is considered. The rounding radius of the plates is 0.8, 1.2, or 1.6 mm. The distribution of the temperature and mechanical stress within each sample and also within the mold is determined. The results are used for preliminary assessment of the possibility of spark plasma sintering of cutting plates.
About the authors
D. I. Yushin
Stankin Moscow State Technical University
Author for correspondence.
Email: yushindenis@gmail.com
Russian Federation, Moscow
A. V. Smirnov
Stankin Moscow State Technical University
Email: yushindenis@gmail.com
Russian Federation, Moscow
N. Solis Pinargote
Stankin Moscow State Technical University
Email: yushindenis@gmail.com
Russian Federation, Moscow
P. Yu. Peretyagin
Stankin Moscow State Technical University
Email: yushindenis@gmail.com
Russian Federation, Moscow
V. A. Kuznetsov
Moscow Statel University of Mechanical Engineering (MAMI)
Email: yushindenis@gmail.com
Russian Federation, Moscow, 107023
R. Torrecillas
Stankin Moscow State Technical University; Centro de Investigación en Nanomateriales y Nanotecnologia (CINN)
Email: yushindenis@gmail.com
Russian Federation, Moscow; Oviedo
Supplementary files
