Enviar artigo por via de e-mail Flash formation in the pulsed laser cutting of thin-walled workpieces
- Autores: Kochergin S.A.1, Morgunov Y.A.2, Saushkin B.P.1,2
-
Afiliações:
- NPO Tekhnomash
- Moscow State University of Mechanical Engineering (MAMI)
- Edição: Volume 36, Nº 5 (2016)
- Páginas: 414-416
- Seção: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/226574
- DOI: https://doi.org/10.3103/S1068798X16050087
- ID: 226574
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
A model of flash formation based on the secondary melting of the cut’s lower edge by superheated melt supplied by a turbulent gas flux is discussed.
Palavras-chave
Sobre autores
S. Kochergin
NPO Tekhnomash
Email: sbp47@mail.ru
Rússia, Moscow, 127018
Yu. Morgunov
Moscow State University of Mechanical Engineering (MAMI)
Email: sbp47@mail.ru
Rússia, Moscow, 107023
B. Saushkin
NPO Tekhnomash; Moscow State University of Mechanical Engineering (MAMI)
Autor responsável pela correspondência
Email: sbp47@mail.ru
Rússia, Moscow, 127018; Moscow, 107023
Arquivos suplementares
