Email this article Influence of cut layer on cutting
- Authors: Kabaldin Y.G.1, Kuz’mishina A.A.1, Zotov V.O.1, Vlasov E.E.1
-
Affiliations:
- Alekseev Nizhny Novgorod State Technical University
- Issue: Vol 37, No 11 (2017)
- Pages: 962-968
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227178
- DOI: https://doi.org/10.3103/S1068798X17110053
- ID: 227178
Cite item
Open Access
Access granted
Subscription Access
Abstract
The contact of the chip with the tool’s front surface in cutting is analyzed by numerical modeling. The high-pressure zones and buildup at the tool’s contact surface are studied. The influence of plastic instability of the chip surface and vortex deformation modes on tool wear is considered.
Keywords
About the authors
Yu. G. Kabaldin
Alekseev Nizhny Novgorod State Technical University
Author for correspondence.
Email: uru.40@mail.ru
Russian Federation, Nizhny Novgorod
A. A. Kuz’mishina
Alekseev Nizhny Novgorod State Technical University
Email: uru.40@mail.ru
Russian Federation, Nizhny Novgorod
V. O. Zotov
Alekseev Nizhny Novgorod State Technical University
Email: uru.40@mail.ru
Russian Federation, Nizhny Novgorod
E. E. Vlasov
Alekseev Nizhny Novgorod State Technical University
Email: uru.40@mail.ru
Russian Federation, Nizhny Novgorod
Supplementary files
