Email this article Simulation of the machining of a bush in the KOMPAS-3D system
- Authors: Shchekin A.V.1, Sul’din S.P.1, Mitin E.V.1
-
Affiliations:
- Ogarev Mordovian State University
- Issue: Vol 37, No 11 (2017)
- Pages: 987-990
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227182
- DOI: https://doi.org/10.3103/S1068798X17110156
- ID: 227182
Cite item
Open Access
Access granted
Subscription Access
Abstract
The KOMPAS-3D CAD system includes a CAM application for turning by means of a numerically controlled module. As an example, the use of this application is considered for the machining of a bush.
About the authors
A. V. Shchekin
Ogarev Mordovian State University
Author for correspondence.
Email: rimstanok@mail.ru
Russian Federation, Saransk
S. P. Sul’din
Ogarev Mordovian State University
Email: rimstanok@mail.ru
Russian Federation, Saransk
E. V. Mitin
Ogarev Mordovian State University
Email: rimstanok@mail.ru
Russian Federation, Saransk
Supplementary files
