Email this article Influence of abrasive-tool overrun on the shape error
- Authors: Vasin A.N.1, Iznairov B.M.1, Davidenko O.Y.1, Reshetnikova O.P.1, Ivanov V.V.1, Bondarev A.K.1, Konovalov V.V.1, Prikazchikov S.Y.1, Melent’ev V.A.1, Shalunov V.V.1
-
Affiliations:
- Gagarin Saratov State Technical University
- Issue: Vol 37, No 11 (2017)
- Pages: 1007-1009
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227187
- DOI: https://doi.org/10.3103/S1068798X17110181
- ID: 227187
Cite item
Open Access
Access granted
Subscription Access
Abstract
The shaping of a part machined by an abrasive tool with overrun is analyzed. Calculation of the overrun associated with minimum shape error—the optimal overrun—is considered.
About the authors
A. N. Vasin
Gagarin Saratov State Technical University
Author for correspondence.
Email: vasin@sstu.ru
Russian Federation, Saratov
B. M. Iznairov
Gagarin Saratov State Technical University
Email: vasin@sstu.ru
Russian Federation, Saratov
O. Yu. Davidenko
Gagarin Saratov State Technical University
Email: vasin@sstu.ru
Russian Federation, Saratov
O. P. Reshetnikova
Gagarin Saratov State Technical University
Email: vasin@sstu.ru
Russian Federation, Saratov
V. V. Ivanov
Gagarin Saratov State Technical University
Email: vasin@sstu.ru
Russian Federation, Saratov
A. K. Bondarev
Gagarin Saratov State Technical University
Email: vasin@sstu.ru
Russian Federation, Saratov
V. V. Konovalov
Gagarin Saratov State Technical University
Email: vasin@sstu.ru
Russian Federation, Saratov
S. Ya. Prikazchikov
Gagarin Saratov State Technical University
Email: vasin@sstu.ru
Russian Federation, Saratov
V. A. Melent’ev
Gagarin Saratov State Technical University
Email: vasin@sstu.ru
Russian Federation, Saratov
V. V. Shalunov
Gagarin Saratov State Technical University
Email: vasin@sstu.ru
Russian Federation, Saratov
Supplementary files
