Email this article Cutting Force in the Machining of Quenched 40Kh and KhVG Steel by Ceramic Tools
- Authors: Pronin A.I.1, Myl’nikov V.V.2, Romanov A.D.3
-
Affiliations:
- Komsomolsk-on-Amur State Technical University
- Nizhny Novgorod State University of Architecture and Construction
- Alekseev Nizhny Novgorod State Technical University
- Issue: Vol 38, No 5 (2018)
- Pages: 360-362
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227441
- DOI: https://doi.org/10.3103/S1068798X18050143
- ID: 227441
Cite item
Open Access
Access granted
Subscription Access
Abstract
The influence of the supply on the cutting force is established in the machining of quenched steel by VOK-60 cutting ceramic. The optimal machining conditions for quenched 40Kh and KhVG steel workpieces are determined.
About the authors
A. I. Pronin
Komsomolsk-on-Amur State Technical University
Author for correspondence.
Email: nil_st@nntu.nnov.ru
Russian Federation, Komsomolsk-on-Amur
V. V. Myl’nikov
Nizhny Novgorod State University of Architecture and Construction
Email: nil_st@nntu.nnov.ru
Russian Federation, Nizhny Novgorod
A. D. Romanov
Alekseev Nizhny Novgorod State Technical University
Email: nil_st@nntu.nnov.ru
Russian Federation, Nizhny Novgorod
Supplementary files
