Email this article Tightness and Leakage in Applying Reinforced Rubber Sleeves to Shafts
- Authors: Erokhin M.N.1, Leonov O.A.1, Kataev Y.V.1, Mel’nikov O.M.1
-
Affiliations:
- Russian State Agrarian University, Moscow Timiryazev Agricultural Academy
- Issue: Vol 39, No 6 (2019)
- Pages: 459-462
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227723
- DOI: https://doi.org/10.3103/S1068798X19060121
- ID: 227723
Cite item
Open Access
Access granted
Subscription Access
Abstract
The influence of radial shaft wobble and misalignment of the sleeve and shaft axes on the onset of leakage in a shaft–sleeve joint is considered. By dimensional analysis, using a multifactorial experiment, a method is developed for determining the minimum functional tightness in the shaft–sleeve joint in terms of leakage onset.
About the authors
M. N. Erokhin
Russian State Agrarian University, Moscow Timiryazev Agricultural Academy
Author for correspondence.
Email: metr@rgau-msha.ru
Russian Federation, Moscow
O. A. Leonov
Russian State Agrarian University, Moscow Timiryazev Agricultural Academy
Email: metr@rgau-msha.ru
Russian Federation, Moscow
Yu. V. Kataev
Russian State Agrarian University, Moscow Timiryazev Agricultural Academy
Email: metr@rgau-msha.ru
Russian Federation, Moscow
O. M. Mel’nikov
Russian State Agrarian University, Moscow Timiryazev Agricultural Academy
Email: metr@rgau-msha.ru
Russian Federation, Moscow
Supplementary files
